6G Celicas Forums

Welcome Guest ( Log In | Register )

> How do I install ignition coil and/or distributor
post Jan 22, 2010 - 4:18 PM
+Quote Post
ravinaziankid

Enthusiast
*
Joined Sep 11, '09
From NYC
Currently Offline

Reputation: 2 (100%)




Hey, I want to know if anyone has a writeup with pictures if possible on how to uninstall/install the ignition coil and distributor. My car died while being test driven by some ricerboy and wouldn't start back up again. It was determined that the ignition is the problem since its not getting any spark. I am also trying to sell the car, so I want to try and fix this as quickly and economical as possible. If not, I might just sell the car as is. Thanks in advance.
 
Start new topic
Replies
post Jan 22, 2010 - 9:58 PM
+Quote Post
808celica



Enthusiast
*****
Joined Feb 24, '07
From Oahu, Hawaii
Currently Offline

Reputation: 23 (100%)




remove spark plug wires
remove cap
set to top dead center (rotor facing spark wire #1
remove connector(s)
remove rotor
remove 2 bolts holding the distrib to the engine (take note on the distrib angle for 94-95yrs for timing, dont know about 96-99yrs)
firmly pull distributor out


--------------------
I don't normally drive fast, but when I do its on a curvy section of this island

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: August 20th, 2025 - 7:25 AM