![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Jun 20, '10 From Scranton, PA Currently Offline Reputation: 2 (100%) ![]() |
Hello all,
Well I want to start this thread so i can ask some questions and chart my prgress as I build this project. This car will be a dule purpose car, run around and weekend worrier doing autocross. here's what I'm starting with... '94 ST 1.8L So I'm thinking I'm going to need the following: new nose: got one on order. coilovers: here I'm thinking about using the Megan Racing Street Series Coilovers for 94-99 Toyota Celica GT/ST FWD Would the BC be a better choice? if so where do I find them. Wheels: Voxx MG3 17x7 Tires: Yokohama S.drive 215/40R-17 87W XL B header & exhaust any subjections???? Best, Roger This post has been edited by RvA944: Jun 21, 2010 - 8:54 PM |
![]() |
![]() |
|
Enthusiast ![]() Joined Jun 20, '10 From Scranton, PA Currently Offline Reputation: 2 (100%) ![]() |
Well I went to a AutoX event last weekend. I couldn't run in it because I lost the radiator the day before. Damn plastic tanks..... but I still wanted to go and check it out. looks like a blast! Next time i got i have to remember the sun block! yeaouch.... And I have some more stuff on order so when it comes in I add to the little beast. I got a feeling I'm going to be looking for more HP out of this pup though. Short of a engine swap what can be done to the 7a for more HP????
I've been doing a lot of playing in my local parking lots (after hours of course) trying to get the feel of this car, and I'll tell adding those tires was a huge improvement over the 15" Goodyear's that were on it when i got it. This is a AT200 so it's got the drums in the rear but I'm looking to change it over to the disks that should help the stopping some. Lenny, I'll check out those pads your talking about for sure. Also I'm going to be starting on the body work here soon. She's got a lot of little dings and a couple of spots that are going to need some real attention to get her flat and ready for paint. Like re-aligning the driver side tail light and the guardrail brush on the pass side rear...... UGH Roger This post has been edited by RvA944: Jul 1, 2010 - 8:44 AM |
![]() ![]() |
Lo-Fi Version | Time is now: August 17th, 2025 - 8:36 PM |