![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Aug 15, '10 From The Best Coast Currently Offline Reputation: 12 (100%) ![]() |
I just talked to a few people about removing the rear license plate bezel, and no one had a 100% answer.i did it on a coupe and im not sure if its different on the hatch or not. So here is how to remove it:
1: Remove the plastic strip above the latch. Just pry it upward as there are only 6 clips that hold it in.(also remove your license plate) ![]() 2.Remove tail lights(3 10mm bolts for the coupe) ![]() 3.Remove the 2 10mm screws on the to right and left of bezel(red is the clips,black is the bolts) 4.Push bezel arms inward so they disconnect from the body clips(very obvious) 5.Pull the 2 bottom clips out of the body of the trunk(still attached to bezel) ![]() 6.Remove the license plate bulb bulbs(spin them) ![]() Install by just reversing the steps. This post has been edited by SupraKid: Jan 9, 2011 - 11:54 PM |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 19, '07 From tx Currently Offline Reputation: 22 (100%) ![]() |
Add to how-to's for future use [?] and give this man a no-prize [Holla if you get that reference
![]() This post has been edited by DEATH: Jan 9, 2011 - 11:12 PM -------------------- ![]() ENGINE: '93 RC 3S-GTE/WRC CT-20b [18-20PSI] PERF: TRD/HKS/ARP/NGK/MSD/ACT/Blitz/STRI/APEX'i/TwosRus/GReddy/Magnaflo/KOYO SUSP: Tein/Bilstein/SusTech/ INT: SS-III SEATS/Toyota Hyper Sports EXT: WRC/TRD/404 Its a safety feature so that people like you don't end up killing themselves or everyone around them. Slow down Paul Walker. 6GC Chat - Go there: [url="http://www.griffgirl.com/forum/chat/index.php[/url] |
![]() ![]() |
Lo-Fi Version | Time is now: August 22nd, 2025 - 3:01 PM |