3" b-midpipes...are there any aftermarket ones available?, custom or pre-made? Options

[chacha]

any one who went swap...did you just custom make your or did you find an after market one?...

if you made one....what type of steel did you use and how much did the shop charge you to weld if you went a shop?

compatibility of the 3" b-midpipe for the st205 work for the st20X?

if aftermarket, which one did you go for?

i found one made by OBX....but not sure of the actual size and quality; anyone have had experience with their midpipe?



OBX midpipe and manifold combo 2.2L

This post has been edited by chacha: Feb 17, 2011 - 11:35 AM

[presure2]

the OBX midpipe is too small for the 3s.
there is no bpipe to fit everyones cars (gt/st dont matter) because there is no one exhaust that everyone uses.
what needs to be done is someone needs to come up with a complete solution, from the end of the downpipe, to the tailpipe.

problem with that is, if it aint under 200$ you guys all complain and whine that a SS autocrap one is fine and they all work, #1, and #2, there isnt enough market to make them.
this is what you guys get for buying those junk chinese brands all these years.

for me to build a bpipe, from the bottom of the downpipe, to the stock cat back location, is over 100$ in materials (in stainless) and a few hrs in labor.
a complete exhaust would be somewhere ~4-500+ depending on muffler and whatnot.