![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Jun 3, '08 From Ireland Currently Offline Reputation: 0 (0%) ![]() |
I was looking at how an oil catch tank would fit in my car today as i have one on the way to stop all the oily crap from the breathers going back into the intake, and i got a bit lost because ive two breathers.
Do i remove and fit the catch tank to the yellow breather or green breather? ![]() Or would i blank off both intake ends and fit the catch tank to both breathers on the engine? Ignore the blue circle, i was missing a bracket but i found it in the boot This post has been edited by Ronan: Feb 1, 2009 - 8:38 AM -------------------- ![]() |
![]() |
![]() |
|
![]() Moderator ![]() ![]() ![]() ![]() ![]() Joined Nov 5, '07 From New Zealand Currently Offline Reputation: 3 (100%) ![]() |
I wouldn't 'attach' it to the motor, I'd find some room in the enginebay for it to sit, and make up a bracket. Turn the PCV around (that goes into the intake manifold) the same way as the one that goes into the intake pipe. run 2 hoses into your oilcatch tank, and either vent to atmosphere or plumb back. (and just bung up the old lines into the manifold/inake pipe you dont use.)
-------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: July 24th, 2025 - 1:57 PM |