3" b-midpipes...are there any aftermarket ones available?, custom or pre-made? Options

[chacha]

any one who went swap...did you just custom make your or did you find an after market one?...

if you made one....what type of steel did you use and how much did the shop charge you to weld if you went a shop?

compatibility of the 3" b-midpipe for the st205 work for the st20X?

if aftermarket, which one did you go for?

i found one made by OBX....but not sure of the actual size and quality; anyone have had experience with their midpipe?



OBX midpipe and manifold combo 2.2L

This post has been edited by chacha: Feb 17, 2011 - 11:35 AM

[cjh4l22]

Hey Manny if you happen to snap a picture of the one you're making for cameron (ted95) I might be interested in something just like what you're doing for him. I feel like once you're past that front section you can piece together part of the middle (cut outs, resonators, mufflers, flex sections, cats, etc...) say, 3feet of it and then the last section is the only other part that would need to be done 'professionally'. Anyway, correct me if I'm wrong or let me know how things work out if you end up doing a 3sgte b-pipe. We could be breaking some pretty big ground here fellas