Fitting an oil catch tank to 3SGE BEAMS Options

[Ronan]

I was looking at how an oil catch tank would fit in my car today as i have one on the way to stop all the oily crap from the breathers going back into the intake, and i got a bit lost because ive two breathers.

Do i remove and fit the catch tank to the yellow breather or green breather?



Or would i blank off both intake ends and fit the catch tank to both breathers on the engine?

Ignore the blue circle, i was missing a bracket but i found it in the boot

This post has been edited by Ronan: Feb 1, 2009 - 8:38 AM

[MaskedMan]

Apparently that just makes me a lower tier Celica enthusiast then

The way I drew the picture is the same way that Presure2 just explained it to you, and how I've been installing oil catch tanks myself. The reasons I don't agree with Rusty's drawing is because he capped off a constant vacuum port on the intake manifold, and because of that, you have no longer have vacuum pulling out crankcase pressure from the valve cover.

Also, have you already purchased your oil catch tank?

edit: If your custom intake does not have a nipple on it for you to attach a hose onto, then you either get one welded on, or just vent to the atmosphere.

This post has been edited by MaskedMan: Feb 19, 2011 - 2:33 AM