Three post riser blocks Options

[gt4st205]

I have searched ever junkyard close to me, and i can't find a two post hatch in white. Forgive me if this is dumb, but has anyone heard of people making blocks for a three post spoilers?

[BlackWidow]

Ok, I understand.
It is possible to create own parts.
You only need a lot of creativity. How high will they be and what form?

You have to take off the spoiler to make a mold where the 3 post will connect, then you can create your own parts.

The easiest way is the take the spoiler and spray the 3 post full with PU-FOAM. (not to much butt in 2 or 3 layers in a couple of hours)
After it is dry, take a hobby knife and cut it in form, and try it on your car.
Take a few parts of glasfiber and polyester resin, and cover the pu-foam.

Then take polyester putty and grease it to the real form.
Rub it with sand-paper till it is real smooth. (if there are any holes, do these 2 steps again

If this job is ready, take carbon fiber and epoxy resin and cover the whole part. The best it will work if you create a vacuum with a plastic bag.
After a day it is dry and start rub it till it is smooth. Repeat this when necessary.

When this is all finisched take some clear varnish and spay it over to get the shiny effect.
After a day a little polish and ready to mount.

I think when you work every day a few hours, this will be ready in 2 weeks.

Good luck and show some pics during the proces

This post has been edited by BlackWidow: Feb 24, 2011 - 3:19 PM