Hello, New member Options

[BillyM81]

I wanted to drop by and say hello. I just got an 94 Celica gt, it's my first import sports car. It should be a lot faster than my last import i used to drive, 86 Nissan Stanza Wagon 4x4.
Now i just got to get used to driving a manual after only driving an automatic for over 10 years.

pics

[Spider77]

CODE 14
1) Disconnect negative battery cable. Wait at least 90 seconds. Remove steering wheel pad. See STEERING WHEEL PAD & SPIRAL CABLE under REMOVAL & INSTALLATION. Disconnect passenger-side air bag connector (if equipped), accessible through finish plate in glove box.
See Fig. 6.
2) Disconnect center air bag sensor connector. Measure resistance between terminals of spiral cable upper connector. If resistance is less than one ohm, go to step 5). If resistance is one or more ohm, disconnect spiral cable lower connector.
3) Measure resistance between terminals of spiral cable upper connector. If resistance is one or more ohm, replace spiral cable. If resistance is less than one ohm, measure resistance between terminals of spiral cable lower connector (connector half that leads to center air bag sensor).
4) If resistance is less than one ohm, go to next step. If resistance is one ohm or more, replace harness between center air bag sensor and spiral cable.
5) Reconnect center air bag sensor connector. Reconnect spiral cable lower connector. Connect a jumper wire between terminals of spiral cable upper connector. Connect a jumper wire between terminals of passenger-side air bag connector (if equipped). Reconnect negative battery cable. Wait at least 2 seconds.
6) Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear codes. See CLEARING CODES under SELF-DIAGNOSTIC SYSTEM. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds.
7) Connect a jumper wire between terminals Tc and E1 of DLC. See Figs. 11 and 12. If Code 14 is displayed, replace center air bag sensor. If Code 14 is not displayed, turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds.
8) Reconnect spiral cable upper connector (steering wheel pad). Reconnect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear codes. See CLEARING CODES under SELF-DIAGNOSTIC SYSTEM. Turn ignition switch to LOCK position. Wait at least 20 seconds.
9) Turn ignition switch to ACC or ON position. Wait at least 20 seconds. If Code 14 is displayed, replace steering wheel pad. If Code 14 is not displayed, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT under DIAGNOSIS & TESTING.


Hope this helps some!


This post has been edited by Spider77: Apr 8, 2011 - 4:20 PM