need help finishin 3sgte install, engine started !! Options

[Needles]

i have some question, plz can someone answer it ?
those should be easy to anwser for any who did the swap

so

question#1 where does this fuel line goes ?



Uploaded with ImageShack.us


Uploaded with ImageShack.us

question#2 where u plug this plastic bottle (the bottom of it)


Uploaded with ImageShack.us
question #3 where do i plug that line ?



Uploaded with ImageShack.us
question #4 how u setup this to this to this ?? plz


Uploaded with ImageShack.us


Uploaded with ImageShack.us


Uploaded with ImageShack.us
question #5 where is the plug for this (lead prestone to the chargercooler) smic)






question# 6
where does that one goes ?


Uploaded with ImageShack.us
questin #7 and finally this one , i dont know where it goes ?


Uploaded with ImageShack.us
question#8 where this 2 plus goes ??


Uploaded with ImageShack.us
thank for any help

This post has been edited by Needles: May 10, 2011 - 2:53 PM

[Needles]

i found my mistake !! the plug for positive on the traNSmission was bad connected, missing the bolt behing, i fixed that,
boosting cable hook, turning the keyall light GOES DOWN ! AND BIG BIG WHITE SMOKE FROM THE GROUND WIRE ( valve cover to front body)the wire tottally burn , it is evidence that i get the starting circuit working, i notice some fuel get out of my filter (was not boltup tight) , but now the big problem is i have bad ground somewhere , and my only wire who burn is the ground engine to body, all other wire are intact. what kind of contact can cause this ?

every fuses is fine, every wire is fine, maybe just my ground setup ?

i think there is too much power goes in the ground wire ( the one who burn engine to front )that make it burn, so it have to be resistance somewhere else to cause that

This post has been edited by Needles: Apr 15, 2011 - 12:40 PM