 gt2860rs .64 rear housing overboost gen3 3s-gte, Fixed overboost (atleast so far) |
 May 14, 2011 - 11:45 AM
|
 
|
 Enthusiast  Joined Feb 11, '08 From Auckland, New Zealand Currently Offline Reputation: 0 (0%)  |
Any suggestions? I want to run 16psi, the included actuator should be 12psi but its spiking to 20psi alot faster than i can let off the throttle
am going to pull the downpipe off and test the actuator with a pump, maybe change from 5mm hose to 8mm hose? (Mr Garry's actuator nipple seems a little bigger than Mr CT's) but has anyone seen this themselves and seen an effective fix short of going external? if my actuator and door are operating as normal, will porting the gate do the trick? any special tricks? This post has been edited by delusionz: May 24, 2011 - 12:18 AM -------------------- Mike W
1996 Toyota Celica ST205 GT-FOUR GT2860RS turbine, TiAL mvr44, JE 86.5φ piston, Clutchmasters FX400, APEX P-FC 269awhp / 273ft-lbs |
 |
Replies
|
May 15, 2011 - 7:18 PM
|
|
|
Enthusiast Joined Feb 5, '09 From New Zealand Currently Offline Reputation: 0 (0%) |
Although i'm going to an external wastegate, i've been advised to run 5psi spring pressure, and let the boost control take it up to 16psi+.
|
Posts in this topic
delusionz gt2860rs .64 rear housing overboost gen3 3s-gte May 14, 2011 - 11:45 AM
Culpable04 make sure to check the downpipe, sometimes the was... May 14, 2011 - 3:14 PM delusionz started with my HKS EVC I hooked up, then tried by... May 14, 2011 - 4:28 PM Rusty Is it an adjustable actuator? Try winding it out a... May 15, 2011 - 2:17 AM presure2 creep is pretty common with the internal gated ... May 15, 2011 - 9:30 AM delusionz Fixed overboost.
The wastegate hole was bored out... May 24, 2011 - 12:25 AM delusionz I dialed my HKS EVC to the 1.0bar marker and hoppe... May 24, 2011 - 10:22 AM delusionz I only managed to push 5500rpm in 3rd gear otherwi... May 24, 2011 - 10:38 AM presure2 excellent!!!
do you have any pics of t... May 28, 2011 - 9:10 AM
delusionz Nope.. done it again. I had a good trashing today,... May 29, 2011 - 6:05 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: June 8th, 2025 - 1:19 AM |