![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Sep 29, '09 From Prince George, BC CANADA EH! Currently Offline Reputation: 8 (100%) ![]() |
Well I'm stumped.
Here are the details 94 ST205 Creaking sound...once every wheel revolution Happens in forward in reverse...more prominent in reverse. Seems to go away when I get up to speed higher than 35ish kmh but maybe I just can't hear it after that. Dead cold it is very quiet but I drove around the block just before the video and it warmed it up enough to be very noisy. Definitely happening every revolution, clutch in or out, transmission neutral or in gear. I put it up on jackstands in the shop and ran it but all 4 wheels were quiet...only happens when on the ground (loaded down I suppose). Unless I get it on a rolling road I think that's the best I can hear Still happens with light to full brake pressure so I doubt it is sticky brake pads. Wheel weights come very close to the caliper but no touching. Just put these wheels on last week...with 15mm hubcentric spacers and longer studs. The car was stored all winter in the shop and I ran all last year with the stock rims. and only spacers in the rear...don't really remember hearing noises like this last year with stock rims but there was some wooga wooga noises coming from up front (which also seems to have gotten worse this year) Seems to be coming from front drivers side but I can hear it well on the pass side as well, and the odd creak on the rear drivers side. I am highly suspect of the wheel/hub bearings. I just tore apart the pass side and had a look at the hub bearings and it certainly doesn't spin like a bearing should, kind of grindy and hard to turn. but would like some other opinions before I drop the big bucks on a couple new ones. They are closed press-in type and bloody expensive...nothing I can just pull and repack Anyways...watch the vid and let me hear your thoughts/concerns Embedded vid Or if that doesn't work you can just download the vid from me directly -------------------- ST205 Crew represent
![]() Challenge Accepted |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Dec 15, '02 From Tasmania(Australia) Currently Offline Reputation: 0 (0%) ![]() |
Can you chuck another set of rims on it to check?
It does happen at the same point in each roation. Sounds like the tire is rubbing on the guard lining or something, i doubt thats the issue but check anyway. Pull the wheel off and check of anything is scrubbing on the driveshaft/cv's/crake rotor etc. I highly doubt its a wheel bearing but check for play anyway. -------------------- ST205 Group A Rallye GT-Four, #61 of 77............600hp GT3582r
GRX133 Toyota Mark X 350s ![]() |
![]() ![]() |
Lo-Fi Version | Time is now: August 18th, 2025 - 7:33 AM |