Nov 7, 2006 - 7:07 PM
|
|
|
Enthusiast ![]() ![]() Joined Aug 20, '06 From Kissimmee Currently Offline Reputation: 0 (50%) |
was trying to connect my indiglow kit thingy and now no lights and my arrows dont move
|
![]() |
Jun 6, 2011 - 10:06 AM
|
|
|
Enthusiast Joined Jun 6, '11 From bulldog1 Currently Offline Reputation: 0 (0%) |
A dab of 3M super weather strip adhesive applied on the tip of a K bob skew is what i used. Gauges love to flex but a little dab on either side of the needles, carefull NOT to glue them worked like a champ. (under the glo gauge and original face) It makes it easier if you pull straight out any stop pins before trying to install and work your way from longest to shortest needles. Then reinsert pins, You may have to add , or camfer holes first so triple check first then when you are positive you can't screw it up, check once more before you start to make a longshoreman blush !!!!
next time use spray on adhesive and just spray it on the back of the indiglo gauges Spray on adhesive doesn't give you much room for error.Once it's set your done. |
rspjean meesed up my speedometer Nov 7, 2006 - 7:07 PM
Stu37363 check your fuses, you may have grounded the cluste... Nov 7, 2006 - 7:11 PM
jdg371 did you put the needle the same way/location that ... Nov 7, 2006 - 9:41 PM
LewFX what did you use to put it on, too thick of tape w... Nov 7, 2006 - 11:09 PM
Remy Did you play with the needles when you took your c... Nov 7, 2006 - 11:33 PM
rspjean no i was very careful not to touch the needles Nov 7, 2006 - 11:35 PM
Stu37363 i could rip my needles out and the lights would st... Nov 8, 2006 - 2:19 PM
rspjean well i fixxed the problem but i went glue crazy an... Nov 8, 2006 - 10:48 PM
Stu37363 next time use spray on adhesive and just spray it ... Nov 9, 2006 - 12:10 AM
chacha installing these suckers are harder than you think... Dec 7, 2006 - 5:00 PM
scootch A dab of 3M super weather strip adhesive applied o... Jun 6, 2011 - 9:59 AM![]() ![]() |
| Lo-Fi Version | Time is now: November 22nd, 2025 - 2:50 AM |