What the Tuck, Wire Tucking the RC Options

[Defgeph]

Hey guys,
So I decided to start tucking my engine bay.
I didn't expect to go as far as I am now, but once I started hiding things, I wanted to hide more & more stuff. I'm not going to the extreme like coomer did, just wanted to clean up the motor a bit.


Engine before I started the tuck, it was neat, but I wanted to venture further.


I started with the passenger side, because its the easiest.
I had to remove the fenders, front bumper, and eventually the hood.



I will get better pics tomorrow, my camera ran out of battery.
Here is a blurry cellphone pic of the frame rail tucked.



I'm happy with the results, then the wiring to the alt and O2 sensor started to annoy me. lol
So I jumped in on the drivers side


Here is some of the tuck and the relocated fuse box


I can't believe how time consuming this is. I have the engine harness out of the car now, I will rewire the entire harness so I can completely hide it.

Blurry pic warning, its getting there.




I still have a ton of work to do on it, consider that the almost half way point, still plenty of things to hide and relocate. I have a feeling I'm gonna pull the engine
I will get some better pics tomorrow.

Any suggestions ?

DEF

[DG_Performance]

water coolant... the middle 16 pin ecu plug... #4 should be a red wire
fuel pump... the 22 pin ecu plug... #6 green with red
i dont remember how you fuel pump was wired but make sure your COR and FPR relays are plugged in before you start diging into possible wire breakage!

the water one is easy fix. it pegs hot cause not getting any signal at all. broken wire or not connected.
fuel pump depending on where you cut could be problem in few areas? you would have to tell me where you were cutting for me to narrow it down to make it easy for you to find.
start with that above and see what happens... you got my phone number if you need harness tech help.
DG