 1994 Celica ST, No Spark |
 Aug 3, 2011 - 8:31 PM
|
 
|
|
Enthusiast Joined Jun 22, '11 From Iowa Currently Offline Reputation: 0 (0%)  |
I've finished throwing a new 7A-FE long block into the car. However it doesn't spark. I put a new distributor...still no spark. Wires test well, everything else is new. WTF am I missing? I've started going through the wire harness looking for damage, have yet to find any.
Is there a security type of thing that disables the spark? No Tachometer movement either. There is power to coil. Sorry to blast the forum, but I didn't find anything on the site. BTW this site was a great resource and addition to my lame Haynes manual. John |
 |
Replies
|
Aug 5, 2011 - 8:48 PM
|
|
|
Enthusiast  Joined Aug 29, '08 From Auckland, New Zealand Currently Offline Reputation: 0 (0%) |
when my ecu was faulty i did get a code 13. replaced whole distributor, leads, plugs, igniter, cap, rotor, coil still no spark, turned out to be the ecu faulty, I took a look at the ecu circuit board and solder had melted. This happened because my battery was knackered and that shorted out my starter motor which im thinking was a chain reaction and fried the ecu also
|
Posts in this topic
jarasman 1994 Celica ST Aug 3, 2011 - 8:31 PM
celica-s could be a busted igniter.
also see if this can ... Aug 3, 2011 - 9:42 PM
jarasman QUOTE (celica-s @ Aug 3, 2011 - 9... Aug 3, 2011 - 9:55 PM stephen_lee does your cel come on with the key on? Aug 3, 2011 - 10:08 PM 99gt3sge check timing, and check if conected the ground to ... Aug 3, 2011 - 11:54 PM jarasman THe car does come on, with no trouble lights.
I... Aug 4, 2011 - 8:16 AM stephen_lee so when u turn the ket on, the check engine light ... Aug 4, 2011 - 8:51 AM jarasman Yes the light comes on as normal, goes off during ... Aug 4, 2011 - 10:11 PM PolliS_5S-FE i had similar problem with 5s. turned out to be th... Aug 5, 2011 - 4:51 AM jarasman Yuck, I would rather somebody tell me to check my ... Aug 5, 2011 - 6:20 PM jarasman I'll dig out the ECU tomorrow. I got a diagno... Aug 5, 2011 - 9:36 PM jarasman No codes with a jumper wire, but the tool picked u... Aug 5, 2011 - 10:28 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: July 26th, 2025 - 8:34 PM |