![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined May 13, '06 From Kaimuki, HI Currently Offline Reputation: 10 (100%) ![]() |
I went to toyota today and while I was there I priced out the exhaust gasket set for the turbo. $132 here..and think that I can use the Gen II gasket set on the Gen III but I'm not sure. I also didn't see it in gen 3 parts reference. The part number for the whole kit is 04175-74030. does the gasket set fit everything? Oil, water, turbo inlet and DP?
-------------------- -Jay
95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other 01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished 02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve |
![]() |
![]() |
|
Enthusiast ![]() ![]() ![]() ![]() Joined Jan 19, '11 From Paraguay, Winchestertonfieldville Currently Offline Reputation: 1 (100%) ![]() |
I believe this is what you are looking for sir!
http://www.ebay.co.uk/itm/TOYOTA-CELICA-ST...=item4834703001 I had my 3rd gen head gasket set come from Great britain took its time but it was all spot on! -------------------- |
![]() ![]() |
Lo-Fi Version | Time is now: September 17th, 2025 - 11:48 AM |