![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Jun 4, '10 From Jax Beach, FL Currently Offline Reputation: 0 (0%) ![]() |
I have a 95 Celica GT just under 200k. It had problems downshifting before, but I had replaced the gear oil and everything was smooth again. Today I stopped at a light and the car wouldnt shift into first...or second or anything. I turned the car off switched it into first then I was able to get it into second, but it wouldnt go any further or back to first. I had to drive home in second with my hazzard lights on. Luckily I was a mile away from home. The clutch seems like it is still strong. Could this be the pressure plate or something similar?
|
![]() |
![]() |
|
Enthusiast ![]() Joined Jun 4, '10 From Jax Beach, FL Currently Offline Reputation: 0 (0%) ![]() |
Second day working on the car and surprisingly no major issues. I got the driver side axel off. It took a few minutes, but I found a nice spot to pry it off without damaging the seal.
I was able to remove 4 bolts on the bearing holder of the passenger axel, but there still seems to be something holding it on the top. Is there any trick to getting off the passenger side? I dont see any nice spots to pry it off with. My car has ABS so I have the little abs sensor on the bottom of the hub...I took out the 10mm bolt holding it and had to pry it off with a screw driver and it split into two magnetic halves with some silicone around it...I hope I didnt break it because I know those are $$$ |
![]() ![]() |
Lo-Fi Version | Time is now: August 20th, 2025 - 10:28 AM |