 Thermostat housing nuts striping (5SFE) |
 Feb 7, 2012 - 1:12 AM
|
 
|
|
Enthusiast Joined May 24, '11 From Glendale, AZ Currently Offline Reputation: 0 (0%)  |
Any hints out there on how to get the thermostat housing nuts off successfully? I finally got the upper one off using vise grips after both my socket and wrench stripped the nut. I swear these things are made out of aluminum. The lower one is starting to strip using the wrench, and I can't get a socket in there between the nut and the A/C compressor. I'm in the middle of a timing belt/water pump replacement and wanted to put a new thermostat in. Should I pull the compressor?
|
 |
Replies
|
Feb 10, 2012 - 2:33 PM
|
|
 Enthusiast  Joined Jun 5, '07 From Santa Maria Currently Offline Reputation: 1 (100%) |
I just used a swivel socket to get mine off. Was a bit of a pain but it came off and went on clean.
--------------------  |
Posts in this topic
warthog1 Thermostat housing nuts striping (5SFE) Feb 7, 2012 - 1:12 AM
Araykhel Those damn things. I should show you the carnage o... Feb 7, 2012 - 1:30 AM Bitter you need a better wrench or socket then, the chine... Feb 7, 2012 - 8:35 AM Spider77 I had this same issue a while back when I wanted t... Feb 7, 2012 - 9:21 AM azian_advanced yes remove the compressor. 3 12mm bolts hold it t... Feb 7, 2012 - 3:28 PM warthog1 Thanks guys, I removed the compressor, used a 6 p... Feb 7, 2012 - 10:11 PM bnr32celica I used a 10mm socket on a 1/4" ratchet with a... Feb 8, 2012 - 2:16 AM
 |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: August 19th, 2025 - 10:22 AM |