Kouki Projectors Question Options

[mechedjun]

Done some research on these but couldn't find the info I was looking for so I'm asking the community for help.

1. To my understanding the USDM low beam bulbs do not fit the projectors (9006 to H4? I think?) so as far as wiring goes do I just take the old wiring off and just resolder to the new ones or do I need a resistor or something in between to get the current down?

2. Does the high beam bulbs the same between USDM and projectors?

Thanks

-Dave

[rave2n]

I think what you are showing in those pictures is not going to work without some modification of the projector housing. I see no where in my projectors for you to install all that jazz unless you gut it, and mount those bulb sockets in by some means. I could be wrong, but I havn't had to remove the bulb from mine. Those shown above look more apt to fitting in the USDM OEM lows.

Regardless, the connectors are irrelevant. Know the wire pin outs, and requesting volts/ampres and make it work.

[smkr3w]

I think what you are showing in those pictures is not going to work without some modification of the projector housing. I see no where in my projectors for you to install all that jazz unless you gut it, and mount those bulb sockets in by some means. I could be wrong, but I havn't had to remove the bulb from mine. Those shown above look more apt to fitting in the USDM OEM lows.

Regardless, the connectors are irrelevant. Know the wire pin outs, and requesting volts/ampres and make it work.

The.pics above are for usdm.. just an example