6G Celicas Forums

Welcome Guest ( Log In | Register )

> 3SGTE not starting.
post Mar 14, 2012 - 6:59 PM
+Quote Post
Soulend



Enthusiast
***
Joined Nov 24, '07
From Tucson, Az
Currently Offline

Reputation: 2 (100%)




Hey everyone, so I am completely stumped now.

after fixing all my major oil water and timing problems, I go to start the car, and it just turns and turns and turns but doesn't actually run... I know my timing is correct.

I've changed the coil wire out, the distro cap, and igniter. just to see if those could cause the problem. I test for spark and fuel, both are fine. I even put fuel into the intake and still nothing.

also, I am sure I only unplugged the radiator. It would start like two weeks ago... I don't get it.

does anyone have any Ideas? frown.gif I just want to get my car running again...

Kevin

This post has been edited by Soulend: Mar 14, 2012 - 7:07 PM
 
Start new topic
Replies
post Mar 14, 2012 - 10:09 PM
+Quote Post
lagos



Enthusiast
*****
Joined Aug 31, '02
From Philadelphia, PA
Currently Offline

Reputation: 8 (100%)




QUOTE (Soulend @ Mar 14, 2012 - 9:15 PM) *
I know for a fact about the igniter and coil are bolted, the injector ground, I can't see it, but I didn't touch them at all.. I didn't even take the engine off any mounts. I mean tomorrow Ill crawl under the car and look.

think there could be anything else?


the injector resistor pack, circuit opening relay, etc...not connected.
This is a 3rd gen, right? Did you do the wiring correctly for the swap?


--------------------
15PSI - 30MPG - Megasquirt Tuned
post Mar 15, 2012 - 2:02 AM
+Quote Post
Soulend



Enthusiast
***
Joined Nov 24, '07
From Tucson, Az
Currently Offline

Reputation: 2 (100%)




QUOTE (lagos @ Mar 14, 2012 - 8:09 PM) *
QUOTE (Soulend @ Mar 14, 2012 - 9:15 PM) *
I know for a fact about the igniter and coil are bolted, the injector ground, I can't see it, but I didn't touch them at all.. I didn't even take the engine off any mounts. I mean tomorrow Ill crawl under the car and look.

think there could be anything else?


the injector resistor pack, circuit opening relay, etc...not connected.
This is a 3rd gen, right? Did you do the wiring correctly for the swap?


I had Tweak'd do the wiring. but that was over a year ago, I remember what ground you are talking about... I was freaking out trying to think of the ground thinking I hadn't actually had it connected all this time, but I know it's connected.

short verse of the story: had water and oil leaks, changing flywheel and clutch. took it to my friends in another city over a weekend. finished, car ran, but had weak RTV on oil pan leaked almost all oil within two miles of friends house, friend also forgot to tighten oil pulley. so far no damage, re did everything over two weeks, and only touched the radiator, and timing belt side. nothing else should have been messed with.

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: July 13th, 2025 - 5:25 AM