TRD Kit and TRD mud flaps, how to fit Options

[T3rrorbyte]

Hi Guys,

I have a set of TRD mudflaps that i want to fit to my 6GC but where i have the TRD kit fitted they dont sit as i expected.

The TRD logo's on the flaps sit's quite high up almost obsured by the kit.

I was wondering if any one had already done this and if so had pictures of that it looks like?

Thanks

[chacha]

i hope they rot in hell for the thief who had stolen my rear mud flap

**Keep in mind, the rear, i had to measure the length of the flap to the mud guards' positioning holes and re-drill the holes in after i have already made sure how much I wanted the flaps to stick out; used washers to cover the pre-drilled holes** the front fitted just fine which i used all three mounting holes...the rear, i ONLY used the two lowered bolt holes...not the top bolt hot. made custom bracket for all four which goes on the bottom for rigid support so the flaps wouldn't flop around too much if that makes sense.**

This is how it show look with car lowered:





This post has been edited by chacha: Mar 17, 2012 - 7:36 PM