ST205 Code 54 Sensor Bridging, Need more information please! Options

[salv]

Ok, so I finally have some time to post this question up!

So my water pump was being noisy. I decided to just purchase the bearings and replace them with the old ones. I got a friend to do this for me and it went well. However, when I turned on the car, It had CEL which happened to be code 54. I checked the fluids and its topped up all the way. The pump IS working since I can see the coolant being moved around and I can put my hand over the IC after a hard drive.

From what I read, the CEL affects power performance. I can notice the difference when the code disappears SOMETIMES. It just pulls so much harder.

So my question is this: I want to bridge the coolant sensor. But I don't know how ;/.





The pictures show the sensor and where to bridge. I understand that, But HOW do I bridge and will I need an extra wire to do it or something? If there are better pics of the sensor that is bridged up close that would be awesome.

I have a friend willing to do it, but he says I should ask you guys for pictures and information since he barely deals with WTA.

How does bridging work?

Any help would be appreciated

Cheers,
Sal

[presure2]

you just bridge the connection with a peice of wire as shown in the pic, then tape it in place with some electrical tape.
or, you can cut off the connector and solder the 2 wires together for a more permanant solution.