SPEC Clutch Kit for the 3SGTE Swap, 3sgte swap using the 5sfe tranny Options

[jcbass7]

I called Spec and ordered my clutch kit for the swap. They actually have a part number now for this set-up, the information is as follows:


Spec's tech phone number:

1-205-491-8581

I talked with Justin, who helped me out a ton, great guy to deal with.

his extension is 108


The part number for the clutch kit is:

ST6225S


The SECOND (2) in that part number is the number to reference what stage clutch you would like. I chose a stage two clutch, which i was told will hold 400 ft/lbs of torque.

If you wanted a stage 3 clutch the number would be as follows:

ST6235S

or a stage 1 (not recommended if you plan to add any power to the 3sgte) would be:

ST6215S

etc.
etc.



For reference this is what Lagos put together:

You need the

5fse - disk
5sfe - throwout bearing
5sfe - alignment tool
3sgte - pressure plate
3sgte - flywheel

The clutch kit includes all BUT the flywheel.

EDIT: The clutch kit they sell is basically a kit for the 3sgte that will bolt onto the 5sfe Tranny. It is the 3s disk with the 5s spline count


For a ballpark figure, i paid 389$ for the stage two clutch kit and after shipping a total of 413$


Hope this helps future swappers!

This post has been edited by jcbass7: Jun 7, 2006 - 2:55 PM

[BonzaiCelica]

yes I know old thread. have you guys continued to have problems with release bearing from spec. Is OEM the way to go???