![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Mar 16, '12 Currently Offline Reputation: 0 (0%) ![]() |
Hi, I recent got an axle, brake pads, rotors, suspension and few other parts as a spares for free, and I am curious from which model are they and if they fit AT200?
I think that all suspensions except superstrut suspension on 6 gen are the same, am I right? Next, brake pads and rotors are also the same on AT and ST right? I got some strange electric line, which I suspect that is ABS sensor but I can't tell; picture below. I am reading on forum that ST and GT axles are different, but in which way and how can I check this? Pictures: ![]() where's the difference, and how much is this part worth? ![]() Here are the connectors, hope it helps |
![]() |
![]() |
|
Enthusiast ![]() Joined Mar 16, '12 Currently Offline Reputation: 0 (0%) ![]() |
I think it came from ST202, but I'm not sure, because this parts were in some older mans garage for more than 2 years, and all I know is that the car had 2.0 liter engine, which means it's not from AT200 model. I was hoping that any of you experts would be able to say where are the differences in axles (I have the passenger axle, LHD car).
|
![]() |
|
Enthusiast ![]() ![]() Joined Jun 25, '08 From CA Currently Offline Reputation: 0 (0%) ![]() |
I think it came from ST202, but I'm not sure, because this parts were in some older mans garage for more than 2 years, and all I know is that the car had 2.0 liter engine, which means it's not from AT200 model. I was hoping that any of you experts would be able to say where are the differences in axles (I have the passenger axle, LHD car). Im pretty sure but the axles for an AT200 wont fit the ST200 models mainly because the engines and transmissions are different, the AT uses the A series engine or the 7A-FE and the transmission is either an A246E for an automatic i Believe (but I could be wrong on the transmission code) and I believe a Manual is a C-series transmission don't know the exact code. the ST200 models use an S-series engine (3S-FE, 3S-GE, 3S-GTE, 5S-FE etc) and automatic transmissions are I believe A-series while manual are E but again I'm not 100% sure. So i don't believe the Axles for a ST200 can be used for an AT200. As far as brakes go I know the front brakes on a USDM GT model are bigger than those on the USDM ST model (Not chassis code but trim level), the GT also has read disc while the ST has drums. Hope than answers some of your questions |
![]() ![]() |
Lo-Fi Version | Time is now: August 27th, 2025 - 10:30 PM |