![]() |
![]() |
![]() |
|
Enthusiast ![]() Joined Feb 28, '03 From So-Cal Currently Offline Reputation: 1 (100%) ![]() |
i need help trying to diagnose a problem i noticed with a celica a recently bought. the front passenger wheel looks off center in the wheel well. when driving, there is a noise coming from that side too. being off center, when i make right turns the wheel rubs on the inside plastic cover. what can be the problem/problems?? thanks in advance guys.
|
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() Joined Oct 29, '11 From Haltom City, Texas Currently Offline Reputation: 1 (100%) ![]() |
I say run the driverside jnto a curb till it matches. The 2 inch shorter wheelbase will be easier in parking lots
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Jul 24, '08 From Canoga Park CA. Currently Offline Reputation: 0 (0%) ![]() |
I say run the driverside jnto a curb till it matches. The 2 inch shorter wheelbase will be easier in parking lots ![]() If someone did not put the strut in correctly it could cause that . If nothing looks bent like the control arm, check the strut tower there is a hole in the bottom half(strut base) then the spring must be in orrectly(seated in rubber bottom), then on the top part they have another little hole . The two holes(are there in case you forget to mark the strut before you take it apart) have to be lined up(up and down) that should put the top 3 bolts at the right angle so when you install it the wheel is perfect. You may have to jack up the car to see the top part of the strut. I just looked at your pic again and I can see your strut is angled back so if the strut is not bent it is not properly installed. I say that because if the control arm is bent it would then bend the strut. Good Luck.>/ This post has been edited by xrav22: Jul 25, 2012 - 4:29 PM |
![]() ![]() |
Lo-Fi Version | Time is now: July 20th, 2025 - 2:32 PM |