Question about wiring fogs, Found a diagram, just have one question about it Options

[HectortheRican]

So I'm going to be wiring up my fogs soon and what I'm planning to do is just reroute the wires to the sidemarker and send those straight to the fog lights and to splice in the sidemarkers to the turn signal's wires so they'll both blink.

Basically what I'm worried about is: Is this feasible? Will I be blowing fuses? Any input is appreciated.

This post has been edited by HectortheRican: Aug 8, 2012 - 6:43 PM

[travisxcore]

I doubt it actually goes to a power wire cause its only a 2amp fuse. The way it says 56B and 56A makes me feel like its talking about a pin in the lighting harness...but see I've never looked at it so I'm not sure. If it wasn't raining like all hell out I'd go look at it and try to figure out for you. Let me see if I can find a diagram for our lighting harness and I'll get back to you.

[HectortheRican]

I doubt it actually goes to a power wire cause its only a 2amp fuse. The way it says 56B and 56A makes me feel like its talking about a pin in the lighting harness...but see I've never looked at it so I'm not sure. If it wasn't raining like all hell out I'd go look at it and try to figure out for you. Let me see if I can find a diagram for our lighting harness and I'll get back to you.

Instead of running that 2A connection to the low beam (I'm assuming that if I do that, the low beams will turn off when the fogs come on) could I just connect that 2A connection to the pos terminal on the battery? That way it's still getting 12V power and the fogs won't turn off the low beams.