 E-153 not completely disengaging, posted this up in engine/trans too |
 Sep 22, 2012 - 6:08 PM
|
 
|
 Enthusiast  Joined Nov 24, '07 From Tucson, Az Currently Offline Reputation: 2 (100%)  |
so I swapped in an LSD e153 this past weekend ( a total bitch project so far) and the damned thing wont completely disengage. I was told a GT slave cylinder would be fine to use, so I used that, I also have a GT master cylinder installed so maybe that is the problem? I have the peddle inside the car adjusted so far that the bolt isn't even touching it anymore.
seriously need help I'm sick of all of these problems Ive been having... Kevin |
 |
Replies
|
Sep 25, 2012 - 2:38 AM
|
|
|
Enthusiast Joined Nov 24, '07 From Tucson, Az Currently Offline Reputation: 2 (100%) |
okay, thanks guys, so my dad is still going to make me that extended push rod, and I think it should still help...
replaced the master cylinder and it totally did help. though I still have a little stiffness in the shifting, and on rare occasions it likes to grab in 1st. but I am going to try another bleed (this time with a vacuum) as I have a cool way to do it with a shop vac lol. on top of that I will try to top off the trans oil (I have had bad luck with the right side seal). anyway I hope that gets everything! Ill let you know later on in the week |
Posts in this topic
Soulend E-153 not completely disengaging Sep 22, 2012 - 6:08 PM
Smaay could be the clutch, the GT slave and master shoul... Sep 24, 2012 - 9:23 AM
Ted95 QUOTE (Smaay @ Sep 24, 2012 - 10:23 ... Sep 24, 2012 - 11:35 AM lagos Could be that you need to bleed it more, but the e... Sep 24, 2012 - 10:58 AM Soulend okay thanks guys,
my dad said he can make one re... Sep 24, 2012 - 1:41 PM enderswift I literally just went through this process. Same e... Sep 24, 2012 - 10:52 PM Smaay you know you can rebuild them for much cheaper tha... Sep 25, 2012 - 8:39 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: November 16th, 2025 - 1:12 PM |