![]() |
![]() |
![]() |
|
Enthusiast ![]() ![]() ![]() Joined Feb 14, '09 From Mid West Currently Offline Reputation: 7 (100%) ![]() |
After doing fender & bumper cover replacement, the right fender bulb went out. No biggie--got new 194 bulbs & replaced both.
On the way home from work, I noticed the temp got higher than it normally gets. Here's the deal-- Only have 1 fan that a PO had wired to the ignition, so it always come on when I start the Celica. Get home from& checked the fan-- nope, not running! Here is my Q-- I don't have access to a millimeter, I do have the thing that lights up when it gets power. What wire(s) should I test? Did NOT get over heated. Checking fuses when I get home tomorrow night. Tips & advice Greatly Appreciated!!! Thanks |
![]() |
![]() |
|
Enthusiast ![]() ![]() ![]() Joined Feb 14, '09 From Mid West Currently Offline Reputation: 7 (100%) ![]() |
How the heck do I unplug the connector that's on the shrowd?? I can't get the 2 tiny things to release, the big 1 is no problem.
If I can get the blasted things to release I could run the wires to test the fan!! Also checked the fuses-- the regular 1s are good, the big square things look coroded. The square things are-- 30amp. 30amp. 30amp. 40amp. { these are inside the car, driver side in the fuse box } |
![]() ![]() |
Lo-Fi Version | Time is now: August 21st, 2025 - 4:38 PM |