Piecing together an engine rebuild kit, need help/tips Options

[Syaoran]

Here's my list: (They're for a 5S-FE)

Bearings:
1. ACL Race 3S-GTE Main Bearings
2. ACL Race 3S-GTE Rod Bearings (using 3S Stock Rods)
3. King Bearings 5S-FE thrust washer (not sure if 3S-GTE one will fit)

Pistons/Rods:
1. CP 8.5:1 Pistons 87.5mm [+.020"] (trying to find a 9.0:1 set, if not I'll have to deck the head to bump up the compression)
2. Included Ring set and pins from CP
3. OEM 3S-GTE rods with ARP 22R/3S-GTE Rod bolts

Gaskets/Seals/Head Stuff:
1. OEM 98+ MLS Headgasket
2. OEM 98+ Oil Pump (will most likely shim it 1.5mm)
3. Will reuse brand new water pump
4. Gen 2 3S-GTE ATS Thermostat (170 deg)
5. ARP Head Studs (www.raceeng.com seems to sell a set specific for the 5S. I was told the 3S set would fit but the two studs below the internal cam drive gears had to be ground down to clear the gears)

What else am I missing? Which seals, etc.?

[Smaay]

i would just get OEM main bearings. the crank doesnt see the loads the rods do so OEM will be fine. get the engine full rebuild kit. it will have all the seals for the head like valve stem and headgasket. its much cheaper to buy the kit.

[Syaoran]

i would just get OEM main bearings. the crank doesnt see the loads the rods do so OEM will be fine. get the engine full rebuild kit. it will have all the seals for the head like valve stem and headgasket. its much cheaper to buy the kit.

Any brand or site to get it from? I'm going to have to get 3S rod bearings anyways if I bought the kit.

EDIT: And just about anything else that isn't a gasket or seal (like the headstuds)

This post has been edited by Syaoran: Oct 18, 2012 - 10:55 AM