Nov 12, 2012 - 7:17 PM
|
|
|
Enthusiast ![]() ![]() ![]() ![]() Joined May 16, '10 From Raleigh Currently Offline Reputation: 12 (100%) |
]Check out this video. My idle bumps just like the vacuum between 550-700rpms. It does this after the car has fully warmed up. Cold start the vacuum and idle hold firm until the engine gets up to operational temperature.
Things I\'ve done: full boost leak test, and repaired the leaks I found. smoke test, and repaired the leaks I found. My question?....what else could cause this? Sticking IACV maybe???? oh yea...it\'s a 3rd gen 3sgte. Fully built...etc...most of you are probably familiar with my build. If not it\'s in the my project section. http://s1190.beta.photobucket.com/user/bsa...403873.mp4.html
This post has been edited by bsamps4: Nov 12, 2012 - 7:18 PM -------------------- ![]() |
![]() |
Nov 12, 2012 - 7:32 PM
|
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Feb 11, '08 From Auckland, New Zealand Currently Offline Reputation: 0 (0%) |
yeah thats very normal, it happens from time to time, usually blipping the throttle gets it back to stable.
for sure clean out your IACV with some carby cleaner, get all the grit out so it turns freely then give it some WD40 to lube it again but yeah, this will still happen from time to time, nothing to worry about btw that idle speed seems a little low, it should be around 900, so check your base ignition timing is set to 10deg in diagnostic mode (when warm) -------------------- Mike W
1996 Toyota Celica ST205 GT-FOUR GT2860RS turbine, TiAL mvr44, JE 86.5φ piston, Clutchmasters FX400, APEX P-FC 269awhp / 273ft-lbs |
bsamps4 Idle Stability/Vacuum WTF???? Nov 12, 2012 - 7:17 PM
bsamps4 Good advise. I will double check the timing., but ... Nov 12, 2012 - 8:02 PM
MotoFoo86 With your idle that low it's no suprise it... Nov 12, 2012 - 9:47 PM
bsamps4 Id love for it to idle right, but what options do ... Nov 13, 2012 - 9:23 AM
Smaay for sure clean out the IAC for starters. Nov 14, 2012 - 10:08 AM
bsamps4 Does the IAC affect idle even after warm up? Nov 14, 2012 - 2:52 PM
enderswift Check the map sensor. My idle went to crap after I... Nov 14, 2012 - 11:03 PM
delusionz thats not an idle adjustment screw, thats a thrott... Nov 14, 2012 - 11:44 PM
delusionz the IACV is plenty big to run fast idle up to 2000... Nov 14, 2012 - 11:48 PM
bsamps4 Yes, I have polyurethane mounts. I actually discon... Nov 15, 2012 - 10:45 AM![]() ![]() |
| Lo-Fi Version | Time is now: November 23rd, 2025 - 5:17 PM |