 Press brake piston into caliper bore?, how to do that? |
 Dec 22, 2012 - 2:15 PM
|
 
|
|
Enthusiast  Joined Sep 9, '12 Currently Offline Reputation: 0 (0%)  |
Can't press piston into caliper bore. Any advice?
This post has been edited by dangqiwu: Jan 2, 2013 - 11:35 PM |
 |
Replies
|
Dec 23, 2012 - 4:50 PM
|
|
|
Enthusiast Joined Sep 9, '12 Currently Offline Reputation: 0 (0%) |
Thanks guys. Finally it moves!!!
The point is the c-clamp should press in the center of the piston with a steel plate or an old brake pad. My mistake was to press piston on the edge. |
Posts in this topic
dangqiwu Press brake piston into caliper bore? Dec 22, 2012 - 2:15 PM
Nial Remove the rubber boot and check for corrosion. Dec 22, 2012 - 2:32 PM
dangqiwu QUOTE (Nial @ Dec 22, 2012 - 3:32 PM... Dec 22, 2012 - 3:18 PM xrav22 QUOTE (dangqiwu @ Dec 22, 2012 - 4:1... Dec 22, 2012 - 3:46 PM Nial I dont think you will need any tools, remove the b... Dec 22, 2012 - 3:44 PM dangqiwu QUOTE (Nial @ Dec 22, 2012 - 3:44 PM... Dec 22, 2012 - 6:33 PM xrav22 QUOTE (dangqiwu @ Dec 22, 2012 - 6:3... Dec 22, 2012 - 8:25 PM dangqiwu QUOTE (xrav22 @ Dec 22, 2012 - 9:25 ... Dec 23, 2012 - 2:58 AM Nial QUOTE (dangqiwu @ Dec 23, 2012 - 2:5... Dec 23, 2012 - 3:27 AM Nial QUOTE (dangqiwu @ Dec 22, 2012 - 6:3... Dec 23, 2012 - 12:23 AM dangqiwu Here is a photo of piston. There is no rust on pis... Dec 23, 2012 - 12:58 PM dangqiwu I found the instruction to remove caliper. It says... Dec 23, 2012 - 1:33 PM Smaay dont worry about doing that. if you need to push t... Dec 23, 2012 - 2:29 PM Nial The piston does look clean so I guess not corrosio... Dec 23, 2012 - 3:00 PM xrav22 QUOTE (dangqiwu @ Dec 23, 2012 - 5:5... Dec 24, 2012 - 8:43 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 21st, 2025 - 2:36 AM |