 mr2 trans. conversion update, Not so good. Need some help..please |
 Mar 4, 2007 - 2:04 PM
|
 
|
|
Enthusiast  Joined Mar 4, '06 From Ohio Currently Offline Reputation: 10 (100%)  |
Ok so I just got my mr2 turbo transmission in my car and took it for a spin today. There is a loud grumbling noise/vibration on acceleration and decel. only.
 Im feeling like its drive axles, but I had them apart and lubricated them and they looked fine. On the driveres side I did use the mr2 inner space and boot assembly. But I used the mr2 inner shaft that goes into the transmission. I used a full spacer (OEM axle spacer) on the passenger side. I didnt use one on the driver side. When I have the front jacked up and spin the wheels the side Im turning spins ok. The other side doesnt move unless I go to the other side and move it by hand. Everthing seems in place and tight. With the car on the ground the axles look straight. I used the st205 rear and drivers motor mounts. Any ideas what may be wrong?????? Thanks-toyotacrazy This post has been edited by toyotacrazy: Mar 4, 2007 - 2:08 PM |
Posts in this topic
toyotacrazy mr2 trans. conversion update Mar 4, 2007 - 2:04 PM
toyotacrazy Ok Im relisting this on the mr2 short axle solutio... Mar 4, 2007 - 6:42 PM Dr_Tweak Are you sure all your lug nuts are tight? Seems li... Mar 4, 2007 - 8:54 PM
toyotacrazy QUOTE(Dr_Tweak @ Mar 4, 2007 - 8:54 ... Mar 5, 2007 - 12:06 AM Supersprynt Of those OEM "spacers" you mean the meta... Mar 5, 2007 - 9:56 AM toyotacrazy Yes I got it in with 2 OEM spacers. And drove the... Mar 5, 2007 - 7:40 PM rjbibeau did you use the angel clips on the axles. without ... Mar 5, 2007 - 7:41 PM toyotacrazy QUOTE(rjbibeau @ Mar 5, 2007 - 7:41 ... Mar 5, 2007 - 7:42 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 1st, 2025 - 4:00 PM |