my SHEMA for error54, dont mind Options

[Needles]

I am struggling to find the pump plug let alone anything else - what an idiot! I am used to fixing 1960s Land Rovers with little electronics! I dont suppose someone can post a picture of an engine bay with an arrow of where it is? Or a picture of the connector or something.

there is no plug for it when u have swap, u need to take the wire for this from the ea1 plug and cut it

[alex1981]

I am struggling to find the pump plug let alone anything else - what an idiot! I am used to fixing 1960s Land Rovers with little electronics! I dont suppose someone can post a picture of an engine bay with an arrow of where it is? Or a picture of the connector or something.

there is no plug for it when u have swap, u need to take the wire for this from the ea1 plug and cut it

I assume by "no plug when u have swap" you mean if mine is a transplanted 3SGTE? Mine isnt - its a genuine GT4 with the 3SGTE, but I am running FMIC, hence getting code 54.

[Needles]

since my last setup did not work , i decide to created my own shema to avoid the code54 error

plz keep in mind that i have design one shema for the swaped one, not for gt4 one,

PLZ , that question is really simple for those who have done it and will take 1 minute to anwser,

so where does the green wire goes in this shema ? (this my own shema)
its suppose to goes to "CDS" fuse 27-3 ,




Uploaded with ImageShack.us

[Needles]

nvmnd

This post has been edited by Needles: Oct 14, 2011 - 12:40 PM