i need help fast, swap trouble Options

[CELICAKIDD324]

hey everyone. I got swap trouble! If i dont get this figured out in the next couple weeks then I may lose my sponsor (corbeau) and i worked very hard to get them. Please help with any ideas. heres whats going on. i put a 2nd gen jdm 3s into a 6 gen gt. I had my harness built by Mike (qatar11) The car will start and idle, low with all vac hooked up, normal with the main vac at the top most part of the air intake manifold un hooked. there are NO engine codes. i cant rev the car only once in a great while and thats rarely. when it does rev it only revs to 3000. i have tested the following with multimeters accordingly with the bgb.all the following test good tps,isc,coil,plug wires (except for coil wire came out bad, one should be here tomorrow), afm,knock,speed, distributor, new cap & rotor, new plugs, head was cleaned shaved, 3 angle valve seating, new head bolts, all new gaskets, new water pump, oil pump, water lines, the only thing left to test is the tvis, well anyway, i cant rev and i can let it idle, pull injector wires 2 and 4 and it changes nothing, i replace all 4 injectors, checked fuel rail, all is good, inj's are to the correct pins on the ecu, not sure if the distributor, fuel resist pack, or ignitor are wired correct as they are diffent from us books, i have a friend with the same engine and we tried his fuel resist pack, ignitor, coil, coil wired, just about everything please help

1, cant rev
2, unplug inj 2 and 4 with no change
3, tested every thing but tvis,
4, fuel press at 37lbs