![]() |
![]() ![]() |
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
i recently had B+G lowering springs installed and a full realignment. When i got my car back, i noticed that it pulled to the right a little bit still and also that my rear suspension was making a rattling/popping noise. I took it back today and told them the problem, and they said the springs were on as tight as they would go and the noise that i was hearing was my struts because they were supposedly worn. I havent had these struts but a year, year and a half. They said that the struts dropped when they had it on the lift and that they're not suppose to do that and that the springs are the only things holding them up. They showed me that 3 loops on the springs were touching eachother on both rears like this
![]() Are they suppose to do that? do i need new struts to get rid of the freakin noise? -------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Feb 19, '04 From austin tx Currently Offline Reputation: 1 (100%) ![]() |
My sportlines do the same thing, haven't had any problems.
-------------------- ![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Dec 27, '03 From Nor Cal Currently Offline Reputation: 0 (0%) ![]() |
They're supposed to do that.
-------------------- "It's ok to be naked girl... I'm an artist!"
1995 AT200 Celica ST: stocked out daily driver... 1984 AE86 Corolla GT-SR5: silvertop 20V 4AGE project car jacked up with goodies... 1991 SW2x MR2 n/a: bare bones hardtop model soon to be... |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
ok, but what about the rattling/popping? do you think my struts are really going out or is it something else?
-------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Jan 28, '05 From Redondo Beach, CA Currently Offline Reputation: 86 (100%) ![]() |
push your car down and if it pops up, they're fine, if they stay sunk, they blown.
-------------------- ![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Apr 16, '05 From Orlando, FL Currently Offline Reputation: 1 (100%) ![]() |
now that uve mentioned that poppin/rattling noise..ive had the same thing happening with mines too for about a month or two now, and it only started happenin after i dropped my car. I think its my struts..so i bought kyb's and started installing them today, I didnt finish cause i had to go to work, but i got a day off tomorrow so i should be done in no time. Hopefully i was right and it was the struts, and that poppin.rattling noise stops. If it stops after puttin in the kyb, then your problem having the same problem im having..and it probably is your struts. --anyone feel free to correct me if im wrong--
-------------------- ![]() |
![]() |
|
![]() Moderator ![]() ![]() ![]() ![]() ![]() Joined Oct 1, '02 From fall river, ma Currently Offline Reputation: 13 (100%) ![]() |
could be the mounts...are they still stock parts?
-------------------- Former Team 5SFTE pro member ;)
![]() 13.6@108MPH, 5SFTE Powered |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
no i replaced the mounts
-------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Feb 7, '03 From Northern Virginia Currently Offline Reputation: 23 (100%) ![]() |
it's not good to have the springs touch though. i had springs that touched before and i didn't pass safety inspection.
|
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined May 22, '03 From NOVA Currently Offline Reputation: 16 (100%) ![]() |
the springs are fine like that, thats how they are designed...you must have gone to one of the retarded shops around here....
but QUOTE They said that the struts dropped when they had it on the lift and that they're not suppose to do that do you mean they fell to the floor or that the strut streched the length of its travel?cause when you lift the car the brake/wheel/ect... makes the strut expand its full length from the force of weight+gravity... the pop..try lubricating the top of your springs with bearing grease, where it meets the top hat..some times this binds and causes a poping noise, also a bearing product can be found for this on www.evilspeed.com if the greasing doens't work then its sumthing else! |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
also when i take off in the morning i have to go real slow to get out of my driveway, and in the back left, i hear a popping noise that gets faster as i go faster, but eventually goes away as i go longer and faster and stops completely when i drive around a little while. Also i did the little test that LewFX told me, and it did pop back up, i can hear the gas in the strut when i do it.
-------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined May 22, '03 From NOVA Currently Offline Reputation: 16 (100%) ![]() |
check your bearings?
|
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
i dont think it could be my bearings because none of this started until i had my lowering springs put on, so its gotta be something to do w/ them
-------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Apr 16, '05 From Orlando, FL Currently Offline Reputation: 1 (100%) ![]() |
alright..i think i figured out what that popping noise is (or at least on my car)..and it wasnt the struts (although having kyb's feels alot smoother that the ol struts)...
now if any of yall know what this part is, let me know..cause i sure dont know what its called or what it even does..(im not that big on suspensions) alright, so behind the strut is the bar lookin like thing that runs vertically, and it is bolted to the strut. Well that bar is attached by a bolt and some type of rubber piece to another metal bar that runs to the other side of the car. Well that bar vertically, at the point which it bolts on to the other bar, the rubber piece is wore out, make the bar loose. So the bar now moves from side to side making a loud pop every time it moves. So everytime u take the slightest bump, ur going to hear that pop. I wish i knew what that part is called..n i dont want to sound stupid but i belive that it is connected to the sway bar or somethin like that. If any of yall mechanics on here know what the part is, and can correct anythin i said wrong, please do so. -------------------- ![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined May 22, '03 From NOVA Currently Offline Reputation: 16 (100%) ![]() |
its called a sway bar end link here is a picture
![]() ![]() ![]() ![]() the 2nd pic is the front sway bar end link, the rest are of the rear |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() Joined Nov 26, '03 From Texas Currently Offline Reputation: 1 (100%) ![]() |
ok, i took it by my usual mechanics place, and all he could tell me is that my sway bar links are worn out 110% lol. He couldnt tell me what the rattling noise i hear is so i guess i'll let him take a look at it sometime. Anyways, thanx for helpin out guys
-------------------- It's not just about getting from point A to point B anymore....
![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Apr 16, '05 From Orlando, FL Currently Offline Reputation: 1 (100%) ![]() |
thnx for the info playr..now i know the name of the part. thats what i was talking bout, and just like FSX, my sway bar links are also wore out. Now just two more questions..do I have to replace the sway bar link on both sides of the car or just that one side..n around how much does that bar go for?
-------------------- ![]() |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Mar 8, '04 From Newport, RI Currently Offline Reputation: 63 (99%) ![]() |
it is always best to replace both at the same time. They are about $60 each from Toyota.
-------------------- |
![]() |
|
![]() Enthusiast ![]() ![]() ![]() ![]() ![]() Joined Jan 28, '05 From Redondo Beach, CA Currently Offline Reputation: 86 (100%) ![]() |
im gonna pick some up at kragen (aka partsamerica or shucks) for $42 Part No. is SL240
-------------------- ![]() |
![]() |
|
![]() Enthusiast ![]() ![]() Joined Apr 16, '05 From Orlando, FL Currently Offline Reputation: 1 (100%) ![]() |
hey lewfx..did u the sway bar end links yet?..i went to the local auto part and theyre $62 a piece..and i c i can save money buy ordering them off of partsamerica. But i was if u ordered and received them yet, jus so i could make sure they sent u the right ones?
-------------------- ![]() |
![]() ![]() |
Lo-Fi Version | Time is now: July 22nd, 2025 - 1:31 PM |