What's your 5sfte 3sgte 2 bar Map Voltages? Options

[penguininatux]

Hey. i installed an msd 2 bar map sensor, and the safc doesnt seem to be working with it very well. With the new 2 bar installed and i go to "SENSOR CHECK", NOT "SENSOR TYPE" i can see the in-1 voltage. It is 2.250 with the car just "ON" NOT STARTED. The stock map sensor was 4.500.

Anyways my quesiton is for people with a 5sfe turbo and a 3sgte map sensor.. What In-1 Voltage are u getting when the car is just "ON" Not STARTED.

ie: go to ETC, and then go to "Sensor Check" to find these voltages on your apexi SAFC II.

AGAIN THESE ARE NOT THE "SENSOR TYPE" IN AND OUT SETTINGS.

I would just like to know the difference in voltage between my MSD 2 bar, and the 3sgte 2 bar, because im considering buying one.

Thanks


Dan.

This post has been edited by penguininatux: May 20, 2006 - 5:53 PM