FS: T3 Turbo, Intercooler, SMT6, etc... Options

[Dr_Tweak]

I've got some turbo parts left over from a setup that I was going to do and never did.

First up, a Garrett T3 Turbo, .48 turbine, 60 trim compressor, oil and water cooled, internal wastegate assembly and actuator included, just rebuilt, never installed. My cost $551, for sale to 6GC members for $500 shipped!



Used 440cc injectors, in good condition. I recommend sending these off to be cleaned and new o-rings installed. $75 for all four INCLUDING SHIPPING.



Brand new Bosch BOV, this is the same thing you would find on the Porsche turbo cars. It has a very handy 1" inlet and outlet, making it perfect for recirculating setups. Just what you need for a budget turbo setup on a 7AFE, for example. $75 shipped.



Oil feed and drain flanges, gaskets, and oil feed restrictor. All brand new. Available as a set for $55 shipped.



Log manifold kit. Everything you need to build a log manifold including the radius plate and the T3 turbine flange, you just need to get the right engine manifold plate. This one here is for a 1ZZFE. I also have the downpipe flange here.

Downpipe flange $20 shipped
Turbo manifold parts NOT INCLUDING ENGINE PLATE $140 shipped
1ZZFE Engine plate $40 shipped

Or everything for $190 shipped.



Perfect Power SMT6, brand new in box, software included, cable included, harness included. All ready to go. This is a very powerful piggyback ECU, and controls both fuel and timing, along with a host of other features. Check out the details at www.perfectpower.com. Killer deal at $365 shipped!



Intercooler: SOLD



I'll consider offers on everything.

-Doc

This post has been edited by Dr_Tweak: Aug 8, 2006 - 9:45 PM