6G Celicas Forums

Welcome Guest ( Log In | Register )

> NEED HELP!!!, engine trouble... need help! NEW PROBLEM!!! look at bo
post Nov 27, 2007 - 4:05 PM
+Quote Post
pittfirefighter



Enthusiast
*****
Joined Oct 10, '06
From Greensburg,PA
Currently Offline

Reputation: 27 (94%)




alright guys, so here's where we're at.... i just bought a 94 swapped gt to 3sgte and had some issues driving it home....

upon completing the engine rebuild we noticed a slight crack in the valve cover and oil ever so slightly dripping out.... i decided to drive home this way and just keep an eye on the oil level and refill when necessary...

after about 4 or 5 hours of driving... very close to home... the single crack had now become two larger cracks losing a significant amount of oil.... i refilled the oil and continued to drive.... it was 3am at this time as well in the middle of the Pa turnpike...

upon getting off the turnpike... when i put it in neutral... my oil pressure immediately dropped to zero and the oil light came on... i pulled over (and by pulled over i mean stalled to the side of the road) and opened the hood, i found the ENTIRE ENGINE BAY covered in oil!!! everything had been soaked down in oil... i had it towed to my garage... $100 bill on thanksgiving day at 4 am... haha... the battery light also came on but i believe thats because the alternator is shot due to the amount of oil on the wire loops.... also spark plugs were drowned in oil

so here's where we are at... took off the valve cover... have a new one on its way.... cams and shims and valves all look clean and don't seem to have any damage from the stall.... cleaned up as much of the oil as i could.... now my plan for action is the following...

-replace valve cover....
-replace alternator i assume
-already drained oil so refill with oil and new filter
-take off cheapy oil gauge pressure unit - which is T'ed at stock sensor - and put on oil gauge
-crank engine without spark to check oil pressure around block
-if pressure is good - run compression test - dry and wet runs

is this the right steps? any other ideas?? could the large amount of oil be coming from the valve cover leaking more?? (is the valve cover pressurized enough to spray oil everywhere and create such a drop in oil pressure with the larger cracks?) should i be looking for another oil leak?

This post has been edited by pittfirefighter: Dec 11, 2007 - 4:02 AM


--------------------
Breaking Axles...

Posts in this topic
- pittfirefighter   NEED HELP!!!   Nov 27, 2007 - 4:05 PM
- - pittfirefighter   bump... any input?   Nov 27, 2007 - 7:10 PM
- - pittfirefighter   midnight bump   Nov 28, 2007 - 12:11 AM
- - pittfirefighter   bump, anyone have any ideas?   Nov 29, 2007 - 4:18 PM
- - lagos   You have the right game plan. Cross your fingers a...   Nov 29, 2007 - 5:15 PM
- - Havok1997GT   Ive never heard of a Valve cover leaking like that...   Nov 29, 2007 - 5:48 PM
- - pittfirefighter   this isn't a valve leak... the cover is litera...   Nov 29, 2007 - 7:14 PM
- - Havok1997GT   WOWOWOWOWOWOWOWOWOWO!!!!!...   Nov 29, 2007 - 8:58 PM
- - pittfirefighter   alright guys here's where i am at... replaced ...   Dec 11, 2007 - 4:01 AM


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: September 3rd, 2025 - 2:55 AM