My rear ss-iii splitters looks weird. . . Options

[whatthe]

I dont know why? here are some night shots, they arnt on propelly yet, i only screwed on 2 screws each side to see how it will look, tomorrow im going to wash down the car and put them on properrly. It might be because if the 2 tone white it has. Its 2nd hand and the white doesnt match my cars white so im going to have to get it repainted. . . tho im going to wait till i get my fronts first and get them done both at the same time.

Besides that fact, i dont know is it my spoiler? or the fact i dont have skirts or fronts yet? they just look out of place, or that im not used to them yet

Heres a Picture

[stetsonaw]

left side looks good, drivers side looks like it is pretty off, but like you said, you only put in 2 screws.

[whatthe]

yeh the right side the hanging down a fair bit + im going to try out that 3m scratch remover and see if i can polish/whiten it up as much as i can and get away with not painting it my car white. Also thinking about going spoilerless and see how it looks, i rekon the 3 point spoiler is ruining the look

This post has been edited by whatthe: Sep 15, 2008 - 6:20 AM

[whatthe]

ummm my right one is popping out a little is there some type of glue or adhesive i could buy to firmly stick it to my body of my car ?

This post has been edited by whatthe: Sep 15, 2008 - 11:20 PM

[Rusty]

you've changed your lights right, maybe something happen then so its not sitting right now?

[whatthe]

Yes my lights have been changed, heres a picture i just took. . they look ok, just ok
your opinion members?

[stetsonaw]

it mainly looks out of place due to the lack of sideskirts... take a pic of the right rear during the day. pretty sure there is an adhesive you can use. another option would be to find a place on the underside to put a screw in... if there is such a place, i know there is on the TRDs, dunno about the ss-iii skirts.

[trdproven]

lol your passenger side is not fitted correctly, the inner ends must meet/touch with the bumper. You can tell because the oem bumper lines should match and blend with the lines on the splitter. Basically the pass side is hanging, you need to pick it up more. Use doublesided tape. Look at my profile for reference.

[whatthe]

lol your passenger side is not fitted correctly, the inner ends must meet/touch with the bumper. You can tell because the oem bumper lines should match and blend with the lines on the splitter. Basically the pass side is hanging, you need to pick it up more. Use doublesided tape. Look at my profile for reference.

yes, if you are refering to the first post pictures, you would know that they werent on properlly
but yes, id be getting double sided tape.

[stevest202]

you can also use silkaflex if you find the tape doesnt work