 anyone taken apart the tail lights? |
 Aug 18, 2011 - 4:05 AM
|
 
|
 Enthusiast  Joined May 13, '06 From Kaimuki, HI Currently Offline Reputation: 10 (100%)  |
I'm cutting into the tails to make my custom LED light boards that I'll be replacing the stock lights with. I was wondering if anyone has taken the lens off of the lights? I see some clips that seem to have glue under them. I kinda want to sand down the inside of the lens so it's flat and then polish it so it's clear. But I don't know if it will lose the red tint, and I don't know how thin it would be after I sanded it flat.
-------------------- -Jay
95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other 01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished 02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve |
Posts in this topic
match220 anyone taken apart the tail lights? Aug 18, 2011 - 4:05 AM
stephen_lee i think the whole plastic is tinted, not just a la... Aug 18, 2011 - 9:09 AM
match220 QUOTE (stephen_lee @ Aug 18, 2011 - 4... Aug 18, 2011 - 2:45 PM stephen_lee i check them every few minutes. im doing the same ... Aug 18, 2011 - 4:48 PM match220 QUOTE (stephen_lee @ Aug 18, 2011 - 11... Aug 18, 2011 - 5:08 PM stephen_lee QUOTE (match220 @ Aug 18, 2011 - 5:0... Aug 19, 2011 - 9:48 PM ACCELICA heat gun or oven will work. I didn't do LEDs ... Aug 24, 2011 - 11:45 PM str8thugginit4ya If you're too worried about "over-cooking... Aug 18, 2011 - 11:19 PM match220 I finally got up the nerve to put it in the oven. ... Sep 1, 2011 - 6:51 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: August 22nd, 2025 - 6:15 PM |