 WTB Gen III 3s valve cover |
 Sep 12, 2012 - 5:44 PM
|
 
|
 Enthusiast  Joined May 13, '06 From Kaimuki, HI Currently Offline Reputation: 10 (100%)  |
I've been using the Gen III 3s n/a valve cover and it's made for the side inlet intake manifold, so my center inlet manifold gets in the way a little bit. It still fits but it's hard getting the valve cover on and off without loosening the intake manifold bolts. I can trade someone my valve cover in exchange for the GT4/MR2 Gen III 3s cover, or I can just buy yours. Thanks!
-------------------- -Jay
95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other 01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished 02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve |
Posts in this topic
match220 WTB Gen III 3s valve cover Sep 12, 2012 - 5:44 PM
MGCustoms325 http://www.6gc.net/forums/index.php?showtopic=8288... Sep 12, 2012 - 6:12 PM  |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: August 26th, 2025 - 5:03 PM |