6G Celicas Forums

Welcome Guest ( Log In | Register )

> oil outlet gen III 3sgte
post Nov 16, 2012 - 12:22 AM
+Quote Post
match220



Enthusiast
***
Joined May 13, '06
From Kaimuki, HI
Currently Offline

Reputation: 10 (100%)




So I'm mainly done with building my formerly parted out engine. Just patching up a few things now that I have the head back on. I'm trying to figure out what the threaded oil outlet is above the oil filter and beside the turbo outlet pipe that feeds the turbo with oil. I think the threads are 10mm. I have it plugged right now. Did a sensor originally go there? The FSM oil diagram just shows oil routing and it doesn't show that being plugged with anything or a sensor that would go there.


--------------------
-Jay

95 GT conv. project car: Manual, Gen III 3sgte, JN pisons, Eagle rods, overbore, crank knife-edged, crank scraper, ARP head/main/flywheel, Autronic EMS, Haltech Dual Wideband O2 controller, Audi 1.8T individual coils, FMIC and SSQV BOV, 3" downpipe, 3" ultra-high-flow cat, 2.5" Borla muffler, +other
01 S2000: FMIC, Haltech EMS, Haltech wideband, 570cc inj, forged pistons/rods, sleeved block, 5 angle valve job, ported and polished
02 R6, all stock, except for braided stainless brake lines, frame sliders, and adjustable brake/clutch leve

Posts in this topic
- match220   oil outlet gen III 3sgte   Nov 16, 2012 - 12:22 AM


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: July 24th, 2025 - 2:33 PM