 CPR Celica Project |
 Apr 28, 2013 - 9:12 AM
|
 
|
 Enthusiast  Joined Sep 25, '11 From GreatSmokyMtns NC Currently Offline Reputation: 3 (100%)  |
First a little about me. Single father of 4 kids. The oldest is 22, youngest is 13. So I dont think there is any way I'm going to be able to keep them away from this car.
We got the Celi a little over a year ago from my sister. It was her daily driver. As I understand she took it to one of the quick oil change places and had the oil changed. three days later it started making noise. "Ckicking" low in the motor. Then just froze up. She knew I liked the car so she gave it to me. It has been sitting for a year in the barn. First idea was a engine swap but I ditched the idea because I need the car to be simple enough to be fixed if the kids breaks down. And my 17 year old son is not taking on his buddy in his Sti. I have done a LOT of reading...and I mean hours. I love this site! This wont be a 200hp car but I'd like to make it a car the looks good and is reliable enough for the kids to get to have fun with. (when they can pry it away from Daddy) Ok, After a lot of searching I found a replacement 7afe with about 122,000. Pulled the valve cover and it looks clean. Still has the wire harness attached. Spent the next few days ordering parts. (95 ST.) I want to know if anyone can think of something I'm missing. I'd like to do all this while the motor is out. Exedy KTY18 Clutch kit.... Toyota OEM Rear main seal. Penzoil Synchrom.... Toyota OEM Axle seals. Oil Filter.... Timing belt Fuel/Gas filter..... Timing belt tensioner Air filter..... Timing belt tensioner spring Distributor cap.... Valve cover gasket Distributor Rotor.... Four spark plug tube seals NGK Wire Set..... Three accessory drive belts NGK Platinum Spark Plugs.... Front crankshaft seal PCV Valve..... Camshaft seal Distributor O-Ring..... Oil Drain Plug & Washer/Seal Ebay Header (Not Headers lol)..... Heat wrap for header Thermostat and gasket...... New Vacuum hoses New Radiator hoses....... CAI Kit 90/93 Accord Turned Flywheel...... Break pads/ Turned roters Pulled motor, Checked motor mounts. And now we wait....  
This post has been edited by fatherof4: Apr 28, 2013 - 9:18 AM -------------------- |
 |
Replies
|
May 27, 2013 - 6:34 PM
|
|
|
Enthusiast Joined Mar 11, '06 From Way South Chicago Currently Offline Reputation: 0 (0%) |
Don't forget the resonator after the cat, otherwise the exhaust will sound pretty harsh with just a muffler. You can run a Magnaflow 4inch or 6inch round muffler in place of the factory resonator if you desire.
-------------------- |
|
May 27, 2013 - 8:49 PM
|
|
|
Enthusiast Joined Sep 25, '11 From GreatSmokyMtns NC Currently Offline Reputation: 3 (100%) |
QUOTE (Bitter @ May 27, 2013 - 7:34 PM)  Don't forget the resonator after the cat, otherwise the exhaust will sound pretty harsh with just a muffler. You can run a Magnaflow 4inch or 6inch round muffler in place of the factory resonator if you desire. I have a Magnaflow Cat/resonator combo then the magnaflow muffler will go on at the end. -------------------- |
Posts in this topic
fatherof4 CPR Celica Project Apr 28, 2013 - 9:12 AM
fatherof4 Got some stuff in this week. Waiting on the head May 4, 2013 - 11:59 AM JoshuaM Another Celi saved
I wish my dad rebuilt a Celic... May 4, 2013 - 7:49 PM fatherof4 Cleaned most of the block today. whats the best wa... May 5, 2013 - 5:45 PM fatherof4 All the Parts came in from Toyota today for the he... May 7, 2013 - 9:51 PM jesse09 Looks like a fun project! Will be well worth t... May 7, 2013 - 10:11 PM rentaspace Great to see another Celica saved from the scrap h... May 7, 2013 - 10:18 PM fatherof4 Head work is finally done. May 11, 2013 - 4:24 PM cheela way to save a celi! We'll see how time you... May 11, 2013 - 5:42 PM fatherof4 Got a little more done today. Had to take a break ... May 12, 2013 - 8:27 PM fatherof4 Hope these sound good. May 16, 2013 - 9:16 PM RabidTRD That's a good setup on the exhaust. I was opti... May 16, 2013 - 10:40 PM fatherof4 Da boy has to work weekends so he helps when he ca... May 17, 2013 - 6:25 AM Syaoran Looks good so far. You mind sharing part number o... May 23, 2013 - 2:31 AM fatherof4 The part Number on the Megaflow is 14832. Ordered ... May 23, 2013 - 5:45 AM Syaoran Thanks.
A 1z swap as in 1zz? May 23, 2013 - 8:22 AM
richee3 QUOTE (Syaoran @ May 23, 2013 - 8:22... May 23, 2013 - 2:06 PM Syaoran QUOTE (richee3 @ May 23, 2013 - 3:06... May 24, 2013 - 11:53 AM kurt95gt QUOTE (richee3 @ May 23, 2013 - 2:06... Jul 7, 2013 - 9:40 PM fatherof4 Had to work alone today but I got it installed. To... May 25, 2013 - 8:12 PM Syaoran Lookin good! May 26, 2013 - 11:13 AM fatherof4 Got some more done today. Tomorrow axles, Brakes a... May 26, 2013 - 6:16 PM fatherof4 It RUNS!!! Started on first try... May 27, 2013 - 5:33 PM fatherof4 http://www.youtube.com/watch?v=-V27Swxepd0 May 27, 2013 - 5:46 PM Syaoran Right at the end that look at the camera felt like... May 27, 2013 - 8:09 PM fatherof4 Exhaust installed today. It was running a little r... May 28, 2013 - 6:30 PM Box QUOTE (fatherof4 @ May 28, 2013 - 6... May 28, 2013 - 6:38 PM Syaoran Check the timing with a timing light.
To read pr... May 28, 2013 - 6:51 PM fatherof4 Thanks, I'll check it this weekend. May 28, 2013 - 8:42 PM ricochet1490 You haven't been given nearly enough props for... May 29, 2013 - 7:57 PM Box "What son?" he says. May 29, 2013 - 8:19 PM RabidTRD Sick! It's always great to see a Celica li... May 29, 2013 - 10:42 PM fatherof4 Just a quick update. CAI is installed. Just receiv... Jul 7, 2013 - 3:21 PM Box Don't blame the site, I've shown exemplary... Jul 7, 2013 - 9:34 PM fatherof4 Stuff to add this winter. Sep 1, 2013 - 12:10 PM fatherof4 Well, It's been almost a year. The car has com... Feb 16, 2014 - 9:22 PM JoshuaM NICE! Feb 16, 2014 - 10:04 PM richee3 Manliest. Wheels. Ever. Feb 16, 2014 - 10:18 PM mkernz22 QUOTE (richee3 @ Feb 16, 2014 - 10:1... Feb 19, 2014 - 2:52 PM njccmd2002 I see whar u did there. Feb 16, 2014 - 11:17 PM Ted95 The wheels live!! Car's looking good m... Feb 19, 2014 - 2:59 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: October 27th, 2025 - 4:23 PM |