Red Top Beams cold start issue, im having a bit of a problem any ideas guys? Options

[1soljaslim5]

Seems like the problem wont go away upon cold start this happens it starts yet idles low i gotta push the gas to at least 2k for about 35 seconds
(sorry for text message ringtone)

and it begins dropping low to about 300 and my car begins to rattle ALOT.


but once the engine is all warmed up it idles here and everything goes back to normal.(same vid posted from previous post)


this coldstart is becoming an issue now any ideas guys?

[1soljaslim5]

So After long awaited weeks look what i got from UPS today Thank you So much Forgmann!!

The moment the package was delivered to my house i was so anxious i quickly opened the box to reveal its contents


got the VSV along with the hoses on connected to the vsv the charcoal canister and other from the vsv to the throttle only issue here is that its being squeezed by this container(still learning )

i also went ahead an got the plug extended


well got so excited quickly installed it here it is now wooooo lol


Still having that cold start issue car will idle high for a few seconds and then drop and stall once engine is warm however no problem with the OEM airbox i did notice its now super quiet like a Prius it responds better when accelerating no more bogging or jerking.
Once i floor it weeeeeeeeeeeee,
man....... it feels AWESOME!!i drove it out for a test drive and i must say im loving it.The Beams seems to want to continue pulling once you pass 7rpm and does not slow down i remember my 5s would pull hard but once in 3rd gear the fun was over . but anyways slow progress being made.

This post has been edited by 1soljaslim5: Dec 27, 2013 - 11:55 PM