Starting 3sgte project, 7afe -> 3sgte motor mount question Options

[94silverst]

Hey everyone!

Well my 7afe is finally giving out! I cracked a few piston rods and now can finally start my new 3sgte project. But before I start, I have a few questions: (keep in mind that I don't know a whole lot about engines but will be working with a mechanic on the swap)

1) How hard is it to make the motor mounts for the 3sgte? Should I do it myself or take it some where?

2) Are 3sgte eBay engines reliable?

3) What tranny should I use and is it an easy swap?

I have looked though past posts, and found some facts leading to some of the answers, but would really like to clear it up 100%.

Thanks everyone!!

Would this be a good buy?
eBay

This post has been edited by 94silverst: Jan 6, 2005 - 7:03 PM

[biglipzit]

I doubt you could just use the existing mounts and drill holes for them onto the frame of your vehicle. I think mounts must be custom fabricated and engine position is a big factor. I am not too sure but i think you can either use the 5sfe or 3sgte tranny but i think for a FF vehicle u would be better using a 5sfe tranny unless u got the engine out of a GT-4. An MR2 tranny wont work. It would be better bringing it to a shop but never heard of 7afe to 3sgte swaps before. Wouldn't u rather do a 20valve 4age swap? It would be easier and cheaper on you. I havent heard anything about the ebay engines. I doubt much people buy from them but they do have warranties which should make it safe to try them.