NEW Cold Air Intake Design!, currently ST... but possible GT Options

[Kwanza26]

So I had to smog my car, and took everything off a while ago... and just recently, I reinstalled my CAI.



As you can see, it's different than typical custom CAI which follow Spedtoe's version, but this works also. There's a little bit of rattle underload, which almost sounds like a stock BOV (unintentional) but overall... neat. It goes into the hole under the fusebox and sits in the same place as the DR CAI design, but it doesn't travel down by the tranny, which IMO, keeps the piping a lot cooler. Overall... it works all the same... but it's something different and something possible for a GT.



If there is a local member around here with a GT that would like to test-fit and possibly have built for them, a custom GT CAI... contact me and we shall see. ;]

[Digndoug]

bump!!

hehe.. old thread, but its just what i was looking for..

did you have to move your fusebox to get the piping in there?
[right][snapback]235115[/snapback][/right]

Well sence i have a similar but not exact il help a lil. I had to un-bolt mine and move it out like 2 inches then just used a self tapeing metal screw to hold it, so its not moving around, but never had a problem. But mine still rattles when i hit a bump, I ends up hittinh which i found out a peace sticking out fromt eh frame-design It gets kinda annoing, but i dontpay attention to it, but every one asks if my cars is going to make it or fall apart when they here it.. haha