PCV Valve Help, How do I remove it from the 5SFE? Options

[94GT]

Well, my Celica finally turned 250,000 yesterday and I figure it's time to replace a few things. I've tried removing and checking the PCV valve before with no luck. It's a sticky little guy. Does anyone know if it twists in place or how I should pry it out? Here are the other things I'm planning to replace as I haven't touched them for the past 100k miles:

Plugs
Wires
Distributor cap
Rotor
Fuel filter

Any suggestions to add to the list would be much appreciated! I'm waiting for the summer and I'm going to get it repainted, too. Lot's of rock chips on the front end from Colorado driving...

-Mike

[erics1one]

Well, my Celica finally turned 250,000 yesterday and I figure it's time to replace a few things.  I've tried removing and checking the PCV valve before with no luck.  It's a sticky little guy.  Does anyone know if it twists in place or how I should pry it out?

...

Any suggestions to add to the list would be much appreciated!  I'm waiting for the summer and I'm going to get it repainted, too.  Lot's of rock chips on the front end from Colorado driving...

-Mike
[right][snapback]258756[/snapback][/right]

Get a tiny flat head screw driver and lift the sides of the bottom ring. Then use a larger flat head, and lift the left and the right side evenly until the bottom half is out. You should be able to lift it out at this point.