 Question about Dr. CAI, A little problem |
 May 25, 2003 - 12:08 AM
|
 
|
 Enthusiast  Joined Oct 16, '02 From Hohenwald, Tennessee Currently Offline Reputation: 1 (100%)  |
I have an aluminum Dr. CAI and it rubs agains the motor mount. I didn't notice it until recently and by then the motor mount had eaten a hole almost all the way through the piping. I didn't know what else to do so I put about 8 layers of heat resistant tape over the hole. Does anyone have any suggestions on what to do?
Also, the CAI bounces around because of the coupling and I can never get it tight enough to stop it from doing that. What could I do to solve that problem? |
 |
Replies
|
Jun 2, 2003 - 2:21 PM
|
|
|
Enthusiast Joined Oct 16, '02 From Hohenwald, Tennessee Currently Offline Reputation: 1 (100%) |
I've tried adjusting the CAI to the position that your's is in, but it just won't go that way. I have mine pushed up into the coupling at the manifold pretty far because if I only push it in a little it bounces around really bad.
|
Posts in this topic
Delta_Phoenix Question about Dr. CAI May 25, 2003 - 12:08 AM
t96f Rubbing-I'd say try adjusting the position, if... May 25, 2003 - 1:01 AM Blackcelliman The only part of my DR. CAI that touches is the to... Jun 2, 2003 - 5:00 AM
 |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: September 14th, 2025 - 3:53 AM |