lots of New problem questions, plugs/pcv/tires/sri Options

[aslearvert]

Will this Distributor cap work? click

How about this PCV valve, and how hard are they to replace? click

Thanks for the help

This post has been edited by aslearvert: Aug 18, 2007 - 2:10 PM

[aslearvert]

Ok, I have my plugs and pcv valve. I have a couple of new questions though.

1. Is there a "how to" on changing plugs? If not can someone just give me a quick run down? I take the wires off, and a huge tube comes out... whats next? Do you loosen the hex head and take it out after you pull the tube out?haha (Sorry, I've never done this before on my car. ) Everyone has to start somewhere right? haha

2. What are the plugs supposed to be gapped to?

3. Where is the PCV valve located? (and how do I replace it) (scratch this, I found it and replaced it)

Also, I figured since I was asking all these questions, I'd ask more.


4. I hooked up my sri before I was on the site, and I am wondering if I hooked it up correctly now. Can someone tell me if there is a better way of doing this?



5. All of my tires are wearing evenly except, my right rear is bald... why would that be? Do I need an alignment?


^^ Right Front



^^ Right rear (problem tire)

sorry about the dirty car... dirt roads suck.

Any help is greatly appreciated
-Thanks

This post has been edited by aslearvert: Aug 18, 2007 - 2:18 PM