My Progress going bad..., thing going wrong now!!!!! Options

[RUNNIN-LOW]

This is what I have done so far. I still have to fab up a downpipe and figure out how to make a IC piping for the snailshell to the intercooler.


ok first picture if you look closely you can see i had to trim my fan haha & im worried cause i only have like about half a inch from the clutch clyinder bleeder valve..

showing off the heat shield i had to fab up to make work

showing how i did the oil feed line and the turbo..i love it!!

third gen block fitting

the real street tunning waste gate and the turbo adapter that muggs let me borrow..it looks good i think

the other side of the wastegate and if you look really close you can see i had to trim the heat shield for it to work

more pictures of the getto rigged fan and how close the turbo sits to the fan and raditor





and my bueaty with the front mount infront haha

ooh muggs i sand blasted the downpipe and painted it with high temp paint over all it looks good but i wont be able to use it cause it doesnt match up with my exhaust so the car will be taken to map performance for a new downpipe..

This post has been edited by RUNNIN-LOW: Oct 27, 2008 - 7:53 AM

[RUNNIN-LOW]

get some bigger injectors!

well i have the stock 540 injectors those should be fine for now plus i have the 255warblo fuel pump. plus im not even boosting hard at all just a couple test runs to see if everything is running fine.
yeah thats what im guessing too that the wastegate is stayin open thats why im struggling to get boost. but its only been like 2 days since the car is runing ill have to do a couple test runs and tweak it around.

yeah and the check engine light flashes sometimes when the car starts to bogg no clue whats going on there too??

This post has been edited by RUNNIN-LOW: Oct 27, 2008 - 1:52 PM